咨询热线:010-61257019
010-61257016
13522701469

在线客服

首 页 > 产品中心 > 车用尾气净化液

车用尾气净化液Vehicle exhaust purification solution

产品类型
Product Type

产品名称
Product Name
车用尾气净化液 Vehicle exhaust purification solution

API等级
API level

粘度级别
Viscosity grades

包装规格
Packing
10KG*2

 帮助治理PM2.5

Help governance PM2.5

直径小于2.5微米的PM2.5微粒可直接进入肺泡,与人体发生应激反应,严重影响健康。它已经成为空气污染中首要的污染物。汽车尾气是PM2.5物质的重要来源,埃尔曼车用尿素溶液是专用于装载SCR系统的柴油车辆的还原剂。它将发动机尾气中的氮氧化物转化为无害的氮气和水,从而大大减低废气和PM2.5污染颗粒的排放量。

Less than 2.5 microns in diameter PM2.5 particles directly into the alveoli, and the human stress response occurs, serious impact on health. It has become the primary pollutant in air pollution. Automobile exhaust is an important source of PM2.5 substance, Ellman automotive urea solution is dedicated to reducing the load SCR system for diesel vehicles. It engine exhaust of nitrogen oxides into harmless nitrogen and water, thereby greatly reducing exhaust emissions and PM2.5 pollution particles.

产品性能:

Performance:

本品为NOX选择性催化还原剂。适用于所有国IV、国V排放柴油发动机SCR系统,本品为SCR技术的标准配制。本品通过与NOX产生选择性催化还原反应,将其转换成氮气、水。从而减少氮氧化合物的排放。SCR技术能起到降低油耗。

This product NOX selective catalytic reducing agent. Applies to all countries IV, V emission diesel engine SCR country systems, SCR technology standard formulated product. This product is produced by selective catalytic NOX reduction reaction, to convert it into nitrogen and water. Thereby reducing emissions of nitrogen oxides. SCR technology can effectively reduce fuel consumption.

使用方法:

How to use:

清除外盖周围沾染土或污物,拧开外盖后打开内盖,然后拧上加注咀加注

Remove contaminated soil around the outer cover or dirt, wring away lid open the inner cover, then screw on the filling spout filling.

加注注意事项:

Fill Note:

1.      加注前确认为尿素溶液箱,防止加入油箱。

 Before filling confirmed urea solution tank to prevent fuel tank added.

2.      尿素溶液不可以和铜、锌铁制容器接触。

  Urea solution can not and copper, zinc iron container in contact.

3.      加注时防止溶液溅入眼睛,一旦进入立即用清水冲洗,必要时立即就医。

 When filling solution to prevent splashing into the eyes, immediately rinse with water once entered, immediate medical attention if necessary.

4.      当溶液由于存放温度过低出现结晶时,将其置于室内完全溶解后再行加注(不影响使用)。

 When the solution crystallization temperature is too low because the store, which was placed in the indoor completely dissolved before filling line (does not affect use).

5.      一次使用不完剩余部分立即将桶盖拧紧防止灰尘落入。

 Finish the remaining portion of the first use immediately tighten the lid to prevent dust falling.

储存条件:

Storage conditions:

请将该产品存储在30℃以下的环境,避免阳光直射。当温度低于-11℃时,车用尿素溶液将结晶,结晶过程不会破坏车用尿素溶液,解冻后车用尿素溶液的浓度和质量将恢复,解冻温度不得超过40℃。存储温度≤10℃,存储期36个月;存储温度≤25℃,存储期18个月;存储温度≤30℃,存储期12个月。

Please store the product in an environment below 30 , avoid direct sunlight. When the temperature is below -11 , automotive urea solution crystallization, the crystallization process does not destroy the car with urea solution, automotive urea solution concentration and quality of the recovery after thawing, thawing temperature not exceeding 40 . Storage temperature 10 , storage period of 36 months; storage temperature 25 , storage period of 18 months; storage temperature 30 , storage period of 12 months.